Table of Contents
Advertisement
The image can be obtained from an external device in which GPS coordinates
were stored at the time of image creation. This could be created in the
"MyDestination" application and imported
Map
Options for map display
›
In the Navigation main menu, tap the function surface .
The following function surfaces are displayed
2D - Two-dimensional map display
3D - Three-dimensional map display
Display of the route from the current vehicle location to the destination
Presentation of the destination or the next interim destination in the map
(depending on the menu item setting) → Advanced settings → Status line:)
Automatic map display in day or night mode (depending on the currently
A
active vehicle lighting)
Daytime map display
B
Night-time map display
C
D
Switch the split screen display on/off
Switch the display of selected POI categories on/off
E
a destination via the map coordinates
Switch the display of Google Earth
F
If the map scale of the 2D Map or 3D Map is greater than 10 km (5 miles), then
the map is automatically displayed as 2D and aligned in the direction of north.
If the scale is increased beyond this value, then the map is switched back to
the original representation.
» Fig. 234
on page 190.
Fig. 237
Map options
» Fig.
237.
» page 185
» page
188, Entering
™
online map on/off
» page 185
Map scale
Fig. 238 Function surfaces for the map scale change
It is possible to change the map scale manually or to turn on the automatic
change of scale.
›
Tap the function surface
» Fig.
A
In area
» Fig.
238, function surfaces for changing the map scale are dis-
B
played.
Types of manual scale change
▶
Touching the screen with two fingers and pulling them apart or closing them
together.
Turn the control knob (not applicable to Infotainment Columbus)
▶
Switch on/off the automatic change of scale
If the automatic scale is active, the map scale will change automatically de-
pending on the type of roads travelled (motorway - smaller map scale / town
larger map scale) and from the manoeuvre to be carried out.
▶
To switch on the automatic scale change, go to the Navigation main menu
and tap on function surface → .
Tap the function surface is highlighted in green.
The automatic scale is only active as long as the map is centred on the vehicle
position (the function surface or is hidden).
▶
To switch off the automatic scale change, go to the Navigation main menu
and tap on function surface → .
The function surface is highlighted in white.
238.
Navigation
193
Advertisement
Table of Contents
