Table of Contents
Advertisement
Fig. 319 Instrument cluster display: Display examples
Read and observe
on page 261 first.
Description of indications and displayed traffic signs
Display
» Fig. 319
Display of detected traffic signs
display)
Additional display (monochromatic display)
Additional display (colour display)
The system can display the following (vertical) traffic signs where identified.
▶
Speed limit.
Overtaking prohibited.
▶
Additional signs, such as 'when wet' or signs which only apply for a limited time
can also be displayed.
The system displays only traffic signs that are in the "viewing area" of the sen-
sor
» Fig.
318.
Data from the sensor is supplemented by information from the Infotainment
Navigation. This is the reason why traffic signs with maximum speeds can also
be shown on sections of roads which do not have any traffic signs.
Warning when exceeding the speed limit
The warning when exceeding the permissible speed (based on the detected
traffic sign) can be activated and set in
Mode when towing a trailer
For vehicles with a factory-fitted towing device, in Infotainment it is possible
to enable or disable the relevant traffic signs for trailer operation and the top
speed for towing a trailer
» page
262
Driving
» page
56, Driving data (Multifunction
Infotainment» page
261.
261, Settings in Infotainment.
Note
If, for example, you are on a motorway without speed limits, then a road sign
relating to the end of all limits is shown in the instrument cluster display.
Additional display
Read and observe
on page 261 first.
If the menu item Road sign is currently not shown
the road sign with the speed limit will appear in the upper display area of the
instrument cluster
» Fig. 319
on page 262 - , .
If several traffic signs are detected simultaneously, in some cases the next
traffic sign will also be displayed in the colour display -
.
All detected traffic signs can be displayed via the multifunction display in the
menu item Traffic Sign Recognition
The additional display can be activated / deactivated in Infotain-
ment» page
261.
Note
The setting (activation/deactivation) of the auxiliary display will be saved (de-
pending on Infotainment type) in the active user account personalisation
» page
59.
Malfunctions and information messages
Read and observe
on page 261 first.
If, for some unknown reason, the system is not available, an appropriate mes-
sage appears in the display of the instrument cluster.
Sensor dirty/covered
If a note appears in relation to the cleaning of the windscreen, clean the wind-
screen or remove the obstruction from the sensor area.
System fault
If an error message appears, seek assistance from a specialist garage.
» Fig. 319
on page 262 - ,
» Fig. 319
on page 262 -
» Fig. 319
on page 262 - .
Advertisement
Table of Contents
