Table of Contents
Advertisement
Fig. 302 Segment display: Examples of Speed Limiter status displays
Read and observe
on page 244 first.
Speed limiter status displays
» Fig.
Speed limit is set, control is inactive (in the colour display the digits of
speed limits is shown in grey).
Control active (in the colour display the digits of the speed limits are high-
lighted).
No speed limit set.
System fault - seek assistance from a specialist garage immediately.
Basic requirements for start of control
The Speed Limiter is activated.
The current speed is greater than approx. 30 km/h.
After starting the system, the current speed is set as the speed limit, the warn-
ing light
lights up in the instrument cluster.
Exceeding the speed limit during the regulation
If, during the control, it is necessary to exceed the speed limit (e.g. to over-
take), the accelerator pedal must be pressed fully.
When exceeding the speed limit (e.g. driving down a hill), an acoustic signal
sounds and the warning light
flashes in the instrument cluster.
The regulation is resumed once the speed has fallen below the set limit.
301,
» Fig. 302
Operation description - Variant without CCS
Read and observe
on page 244 first.
Overview of the speed limiter controls
Activate speed limiters
A
Interrupt control (spring-tensioned position)
Disable speed Limiter (delete set limit )
Take control again
B
a)
of 1 km/h), hold (in increments of 10 km/h)
Start control/ reduce speed limit - press (in increments of 1 km/h),
C
hold (in increments of 10 km/h)
a)
If no speed limit is set, the current speed is set as the speed limit.
Fig. 303
Controls of the speed limiter
(version without CCS)
» Fig. 303
/ increase speed limit - press (in increments
Assist systems
245
Advertisement
Table of Contents
