Table of Contents
Advertisement
CAUTION
Never exceed the maximum permissible load of the holder - there is a risk of
damage or functional impairment.
Attaching the rear headrests
Fig. 140 Inserting: Adapter/Holder
Fig. 141 Removing: holder/adapter
Read and observe
on page 108 first.
›
Toinsert, attach the opened adapter to the guide rods of the front headrest
and clip in the direction of arrow
›
Clip in the holder in the direction of arrow
›
To remove, pull on the securing tab
holder out of the adapter in the direction of arrow
›
Press the adapter and remove in the direction of the arrow
guide rods of the headrest.
108
Operation
» Fig. 140
»
.
1
into the adapter.
2
in direction of arrow
and take the
A
3
» Fig.
141.
4
from the
5
WARNING
Be careful with the adapter- otherwise there is a risk of finger injury.
Handling the holder
Fig. 142 Tilting and rotating the holder
Read and observe
on page 108 first.
The holder may be by 30° in the direction of the arrow
in the direction of arrow
turned
2
›
To adjust the holder size, pull out the securing tab
row
and push the part
in the direction of arrow
3
B
tion
» Fig.
143.
Note
If there is no external device in the holder, then we recommend that the part
is moved down fully. Otherwise, irritating noise may occur at certain
B
speeds.
Fig. 143
Adjusting the holder size
tipped and by 360°
1
» Fig.
142.
in the direction of ar-
A
to the desired posi-
4
Advertisement
Table of Contents
