Installing The Tilt Limiter - Yamaha F150A Service Manual

10. Remove the bracket "1" and cap "2" from
the speed sensor coupler "a".
11. Connect the speed sensor coupler "a" to
the speed sensor "1".
a
1
12. Install the rubber seal in the area "a" of
the rigging grommet.
a

Installing the tilt limiter

The models with dual steering cable cannot
be fitted with a tilt limiter.
1. Disconnect the battery cable from the
battery.
2. If there is any grease, clean the surface
of through tube "1" to which the holder is
to be installed.
3. Install the holder "2" so that the protru-
1
a
4. Install the collar "3" and tighten the clamp
2
TIP:
Tighten the clamp screw "4" to the extent that
the magnet lever can be moved manually to
adjust the tilt limiter.
5. Install the sensor "1" on the swivel
6. Fasten the tilt limiter lead "1" using the
3-16
Optional equipment
sion "a" on the magnet lever is aligned
with the groove "b" in the through tube
"1", and the protrusion "c" on the holder is
aligned with the hole "d" in the through
tube "1".
screw "4" temporarily.
2
c
4
3
b
1
bracket.
1
holder "2".
a
1
d
c
0
1
2
3
4
5
6
7
8
9
10
A