Yamaha F150A Service Manual page 88

Make sure to keep the clearance of
50.8mm (2.0 in) or more between the out-
board motor and the motor well.
1. Check that there is no interference
between the steering system and the tilt
limiter when the outboard motor is
steered.
2. Connect the battery cables.
3. Decide the tilt up angle "a".
TIP:
The tilt up angle can be set at any tilt setting
range.
a
4. Align the mark "a" on the magnet with the
desired angle indicated on the sensor.
TIP:
The scales on the sensor indicate the
approximate angles from the full trim down
position.
Example:
If the desired tilt up angle is 35°, align the
mark "a" on the magnet with the scale mark
"b" on the sensor.
5. Operate the PTT switch on the bottom
cowling to tilt the outboard motor up.
6. Check that the outboard motor stops at
set position.
7. Tilt the outboard motor down to adjust
the position of the magnet "1" if the set-
ting angle needs to be adjusted.
TIP:
• To adjust the tilt up angle higher: "a"
• To adjust the tilt up angle lower: "b"
8. Tighten the clamp screw "1" to the speci-
fied torque, and then recheck the tilt up
angle.
3-19
Optional equipment
a
b
b
1
a
1