Installing The Ptt Unit - Yamaha F150A Service Manual

Installing the PTT unit

• After tilting the swivel bracket up, make
sure to support it using the tilt stop
lever.
• When installing the PTT unit with the
power unit installed, make sure to sus-
pend the outboard motor.
1. Connect the battery jumper leads to the
PTT motor lead "1" to retract the PTT
rams.
1
G L
Ram PTT motor lead
Green (G)
Retract
Blue (L)
2. Fully tilt the swivel bracket up, and then
support it using the tilt stop lever "1".
1
3. Install the bushings "1", PTT unit "2", and
lower mounting shaft "3", and then
tighten the lower mounting shaft bolts "4"
to the specified torque.
4
Lower mounting shaft bolt "4":
4. Pass the PTT motor lead "1" through the
Battery
5. Connect the battery jumper leads to the
(+)
(–)
6. Install the upper mounting shaft "1" and
9-39
3
39 N·m (3.9 kgf·m, 28.8 ft·lb)
hole "a" in the clamp bracket (PORT).
PTT motor lead "1" to extend the PTT
rams until the end of the tilt ram is
aligned with the mounting position hole.
1
L
G
Ram PTT motor lead
Blue (L)
Extend
Green (G)
circlip "2".
PTT unit
4
1
1
2
1
1
a
Battery
(+)
(–)