Changing Power Tuning Settings - 3Com 3CRWX120695A, 3CRWX440095A Configuration Manual

Changing RF Auto-Tuning Settings 199
To change the channel tuning interval, use the following command:
set radio-profile name auto-tune channel-interval seconds
To set the channel tuning interval for radios in radio profile rp2 to 2700
seconds (45 minutes), type the following command:
WX1200# set radio-profile rp2 auto-tune channel-interval 2700
success: change accepted.
Changing the Channel Holddown Interval
The default channel holddown interval is 900 seconds. You can change
the interval to a value from 0 to 65535 seconds. To change the channel
holddown interval, use the following command:
set radio-profile name auto-tune channel-holddown holddown
To change the channel holddown for radios in radio profile rp2 to 600
seconds, type the following command:
WX1200# set radio-profile rp2 auto-tune channel-holddown 600
success: change accepted.
Changing Power Enabling Power Tuning
Tuning Settings
RF Auto-Tuning for power is disabled by default. To enable or disable the
feature for all radios in a radio profile, use the following command:
set radio-profile name auto-tune
power-config {enable | disable}
To enable power tuning for radios in the rp2 radio profile, type the
following command:
WX1200# set radio-profile rp2 auto-tune power-config enable
success: change accepted.
Changing the Power Tuning Interval
The default power tuning interval is 300 seconds. You can change the
interval to a value from 1 to 65535 seconds. To change the power tuning
interval, use the following command:
set radio-profile name auto-tune power-interval seconds