Table of Contents
Advertisement
188
C
7: C
HAPTER
ONFIGURING
WX1200# set ap 5,6 radio 1 radio-profile rp2 mode enable
success: change accepted.
WX1200# set ap 6 radio 2 radio-profile rp2 mode enable
success: change accepted.
WX1200# display ap config
Por: AP model: mp-241, POE:
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11a, mode:
tx pwr:
1, profile: rp2
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Port
6: AP model: mp-252, POE:
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode:
tx pwr:
1, profile: rp2
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Radio 2: type: 802.11a, mode: enabled, channel: 36
tx pwr:
1, profile: rp2
auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10
U
E
SER
NCRYPTION
WX1200# display service-profile wpa-wep
ssid-name:
beacon:
WEP Key 1 value:
WEP Key 3 value:
WEP Unicast Index:
Long Preamble:
WPA enabled:
ciphers: cipher-tkip, cipher-wep40
authentication: 802.1X
TKIP countermeasures time: 60000ms
7 Map service profile wpa-wep to radio profile rp2. Type the following
commands:
WX1200# set radio-profile rp2 service-profile wpa-wep
success: change accepted.
8 Apply radio profile rp2 to radio 1 on port 5 and to radios 1 and 2 on
port 6, enable the radios, and verify the configuration changes. Type the
following commands:
enable, bias: high, name: MAP05
enabled, channel: 36
enable, bias: high, name: MAP11
enabled, channel: 6
9 Save the configuration. Type the following command:
WX1200# save config
success: configuration saved.
mycorp
ssid-type:
yes
auth-fallthru: last-resort
<none>
WEP Key 2 value:
<none>
WEP Key 4 value:
1
WEP Multicast Index:
YES
Shared Key Auth:
crypto
<none>
<none>
1
NO
Advertisement
Table of Contents
