Table of Contents
Advertisement
Setting the 802.1X
Timeout for a Client
Displaying 802.1X
Information
Viewing 802.1X
Clients
WX1200# display dot1x clients
MAC Address
-------------
00:20:a6:48:01:1f
success: dot1x auth-server timeout set to 60.
To reset the 802.1X authorization server timeout to the default, type the
following command:
WX1200# clear dot1x timeout auth-server
success: change accepted.
Use the following command to set the number of seconds before the WX
switch times out an authentication session with a supplicant (client):
set dot1x timeout supplicant seconds
The default is 30 seconds. The range of time is from 1 to 65,535 seconds.
For example, type the following command to set the number of seconds
for a timeout to 300:
WX1200# set dot1x timeout supplicant 300
success: dot1x supplicant timeout set to 300.
Type the following command to reset the timeout period:
WX1200# clear dot1x timeout supplicant
success: change accepted.
This command displays 802.1X information for clients, statistics, VLANs,
and configuration.
display dot1x {clients | stats | config}
display dot1x clients displays the username, MAC address, VLAN,
and state of active 802.1X clients.
display dot1x config displays a summary of the current
configuration.
display dot1x stats displays global 802.1X statistical information
associated with connecting and authenticating.
Type the following command to display active 802.1X clients:
State
-------
Connecting
Displaying 802.1X Information
Vlan
------
(unknown)
Identity
----------
363
Advertisement
Table of Contents
