Table of Contents
Advertisement
410
C
A: T
WX S
HAPTER
ROUBLESHOOTING A
WITCH
For example, the following command displays all messages at the error
severity level or higher:
WX1200# display log buffer severity error
SYS Jun 02 17:41:35. 176214 ERROR nos_vms_port?add:
Failed to set default vlan v1 an:4096 for port 3 rc 1
To filter the event log by MSS area, use the facility facility-name
keyword. For a list of facilities for which you can view event messages,
type the following command:
WX1200# display log buffer facility ?
<facility name>
Select one of: KERNEL, AAA,
SYSLOGD, ACL, APM, ARP,ASO, BOOT, CLI, CLUSTER, COPP,
CRYPTO, DOT1X, ENCAP,ETHERNET, GATEWAY, HTTPD, IGMP, IP,
MISC, NOSE, NP, RAND, RESOLV, RIB, ROAM, ROGUE, SM,
SNMPD, SPAN, STORE, SYS, TAGMGR, TBRIDGE, TCPSSL,
TELNET, TFTP, TLS, TUNNEL, VLAN, X509, XML, MAP,
RAPDA, WEBVIEW, EAP, PORTCONFIG, FP.
To clear the buffer, type the following command:
WX1200# clear log buffer
To disable logging to the system buffer, type the following command:
WX1200# set log buffer disable
Logging to the Console
By default, console logging is enabled and messages at the error level and
higher are sent to the console.
To modify console logging, use the following command:
set log console severity severity-level
(See Table 39 on page 408 for information on severity levels.)
For example, to set logging to the console for events at the critical
severity level and higher, type the following command:
WX1200# set log console severity critical
success: command accepted.
To disable console logging, type the following command:
WX1200# set log console disable
success: change accepted.
Advertisement
Table of Contents
