Table of Contents
Advertisement
Configuring the Channel and Transmit Power
To set the channel and transmit power of a radio, use the following
commands:
set {ap port-list | dap dap-num} radio {1 | 2} channel channel-number
set {ap port-list | dap dap-num} radio {1 | 2} tx-power power-level
If RF Auto-Tuning is enabled for channels or power, you cannot set the
channels or power manually using the commands in this section. See
Chapter 8, "Configuring RF Auto-Tuning," on page 193.
The parameters are shown in separate commands for simplicity.
However, you can use the channel and tx-power parameters on the
same command line.
Specify 1 or 2 for the radio number:
For an AP2750, AP7250, AP8250, MP-241, MP-341, or MP-101,
specify radio 1.
For an 802.11b/g radio on an AP8750, MP-252, MP-262, or MP-352,
or an 802.11b radio on an MP-122, specify radio 1.
For an 802.11a radio on an AP8750, MP-252, MP-262, MP-352, or
MP-122, specify radio 2.
The maximum transmit power you can configure on any 3Com radio is
the highest setting allowed for the country of operation or the highest
setting supported on the hardware, whichever is lower.
To configure the 802.11b radio on port 1 for channel 1 with a transmit
power of 10 dBm, type the following command:
WX1200# set ap 1 radio 1 channel 1 tx-power 10
success: change accepted.
To configure the 802.11a radio on port 5 for channel 36 with a transmit
power of 10 dBm, type the following command:
WX1200# set ap 5 radio 2 channel 36 tx-power 10
success: change accepted.
You also can change the channel and transmit power on an individual
basis.
Configuring MAP Access Points
155
Advertisement
Table of Contents
