Table of Contents
Advertisement
144
C
6: C
HAPTER
ONFIGURING
MAP A
P
CCESS
OINTS
Changing MAP Names
The default name of a directly attached MAP is based on the port number
of the MAP access port attached to the MAP. For example, the default
name for a MAP on MAP access port 1 is MAP01. The default name of a
Distributed MAP is based on the number you assign to it when you
configure the connection. For example, the default name for Distributed
MAP 1 is DMP01.
MAP names appear in the output of some CLI display commands and in
3Com Wireless Switch Manager. To change the name of a MAP, use the
following command:
set {ap port-list | dap dap-num} name name
Changing Bias
The CLI commands described in this section enable you to change the
bias for a MAP.
To change the bias of a MAP, use the following command:
{
ap port-list | dap dap-num} bias
set
The default bias is high.
To change the bias for a Distributed MAP to low, type the following
command:
WX1200# set dap 1 bias low
success: change accepted.
Configuring a Load-Balancing Group
A load-balancing group is a named set of MAP access points. MSS
balances user sessions among the access points in the group.
To assign a MAP access point to a load-balancing group, use the
following command:
{
ap port-list | dap dap-num} group name
set
To configure a load-balancing group named loadbalance1 that contains
directly-connected MAP access points on ports 1, 4, and 6, type the
following command:
WX1200# set ap 1,4,6 group loadbalance1
success: change accepted.
{
|
}
high
low
Advertisement
Table of Contents
