3Com 3CRWX120695A, 3CRWX440095A Configuration Manual page 178

178 C 7: C
HAPTER ONFIGURING
U E
SER NCRYPTION
WEP Key 1 value:
WEP Key 3 value:
WEP Unicast Index:
Shared Key Auth:
WPA enabled:
ciphers: cipher-tkip, cipher-wep40
authentication: 802.1X
TKIP countermeasures time: 30000ms
The WPA settings appear at the bottom of the output.
The WPA fields appear in the display service-profile output only when
WPA is enabled.
Assigning the Service Profile to Radios and Enabling the Radios
After you configure WPA settings in a service profile, you can map the
service profile to a radio profile, assign the radio profile to radios, and
enable the radios to activate the settings.
To map a service profile to a radio profile, use the following command:
set radio-profile name service-profile name
To assign a radio profile to radios and enable the radios, use the
following command:
set ap port-list radio {1 | 2} radio-profile name
mode {enable | disable}
To map service profile wpa to radio profile bldg1, type the following
command:
WX1200# set radio-profile blgd1 service-profile wpa
success: change accepted.
To assign radio profile bldg1 to radio 1 on ports 1-3, and 5 and enable
the radios, type the following command:
WX1200# set ap 1-3,5 radio 1 radio-profile bldg1 mode enable
success: change accepted.
To assign radio profile bldg1 to radio 2 on ports 1-2 and port 6 and
enable the radios, type the following command:
WX1200# set ap 1-2,6 radio 2 radio-profile bldg1 mode enable
success: change accepted.
<none> WEP Key 2 value:
<none> WEP Key 4 value:
1 WEP Multicast Index:
NO
<none>
<none>
1