Table of Contents
Advertisement
Ignoring Friendly
Third-Party Devices
WX1200#clear rfdetect countermeasures mac aa:bb:cc:11:22:33
success:
clear rfdetect countermeasures mac
aa:bb:cc:11:22:33
By default, when countermeasures are enabled, MSS considers any
unknown transmitter to be a rogue device and can send
countermeasures to prevent clients from using that device. To prevent
MSS from sending countermeasures against a friendly device, add the
device to the known devices list.
To add a device to the ignore list, use the following command:
set rfdetect ignore mac-addr
The mac-addr is the BSSID of the device you want to ignore.
If you try to initiate countermeasures against a device on the ignore list,
the ignore list takes precedence and MSS does not issue the
countermeasures. Countermeasures apply only to rogue devices.
To ignore BSSID aa:bb:cc:11:22:33 during all RF scans, type the following
command:
WX1200# set rfdetect ignore aa:bb:cc:11:22:33
success:
MAC aa:bb:cc:11:22:33 is now ignored.
To remove a BSSID from the ignore list, use the following command:
clear rfdetect ignore mac-addr
To display the ignore list, use the following command:
display rfdetect ignore
The following command displays an ignore list containing two BSSIDs:
WX1200# display rfdetect ignore
Total number of entries: 2
Ignore MAC
-----------------
aa:bb:cc:11:22:33
aa:bb:cc:44:55:66
Ignoring Friendly Third-Party Devices
381
Advertisement
Table of Contents
