Table of Contents
Advertisement
146
C
6: C
MAP A
P
HAPTER
ONFIGURING
CCESS
OINTS
(To display service profile information, see "Displaying Service Profile
Information" on page 161.)
To create a service profile and assign an SSID to it, use the following
command:
set service-profile name ssid-name ssid-name
An SSID can be up to 32 alphanumeric characters long and cannot
contain blanks.
The following command configures a service profile named corp1, and
assigns SSID mycorp_rnd to it:
WX1200# set service-profile corp1 ssid-name mycorp_rnd
success: change accepted.
Disabling or Reenabling Encryption for an SSID
To specify whether the SSID is encrypted or unencrypted, use the
following command:
set service-profile name ssid-type [clear | crypto]
The default is crypto.
Disabling or Reenabling Beaconing of an SSID
To specify whether the SSID is beaconed, use the following command:
set service-profile name beaconed {enable | disable}
SSIDs are beaconed by default.
A MAP radio responds to an 802.11 probe any request only for a
beaconed SSID. A client that sends a probe any request receives a
separate response for each of the beaconed SSIDs supported by a radio.
For a nonbeaconed SSID, radios respond only to directed 802.11 probe
requests that match the nonbeaconed SSID's SSID string.
When you disable beaconing for an SSID, the radio still sends beacon
frames, but the SSID name in the frames is blank.
Changing the Fallthru Authentication Type
By default, MSS uses WebAAA for users who do not match an 802.1X or
MAC authentication rule, and therefore fall through these authentication
types. You can change the fallthru method to last-resort or none.
Advertisement
Table of Contents
