Consumable/Routine Maintenance Procedures; Insert Fuser - Xerox Phaser 6280 Service Manual

Consumable/Routine Maintenance Procedures

Insert Fuser

Phaser 6280 Color Laser Printer Service Manual
The printer does not detect the presence of the Fuser.
Warning
The Fuser may be hot. Turn the printer power Off and allow at least 5
minutes for the Fuser to cool before removing the Fuser.
Applicable Chain Link
Chain Link
Initial Actions
Ensure that the Fuser latches are fully locked.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Fuser, PL6.1.10
Fuser Harness, PL6.1.11
MCU Board, PL9.1.20
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Check the Fuser for correct installation.
2. Is the Fuser correctly installed?
2 Does the error still occur?
1. Check the wiring harness connectors P/
3
J17 and P/J171 between the MCU Board
and the Fuser.*
2. Are the connectors securely connected?
010-317: IOT Fuser Detached
Wiring and Plug/Jack Map Reference
"Map 1 - Electrical and Drive" on
page 10-9
"Map 4 - LVPS and MCU Boards" on
page 10-12
"Fuser" on page 10-35
Error Messages and Codes
Yes No
Go to step 3. Reseat the
Fuser
(page 8-11).
Go to step 2.
Go to step 3. Complete.
Go to step 4. Reconnect
the
connectors.
Go to step 4.
3-51