Ready Fuser Life - Xerox Phaser 6280 Service Manual

Ready Fuser Life

Phaser 6280 Color Laser Printer Service Manual
The Fuser has reached its end of life.
Warning
The Fuser may be hot. Turn the printer power Off and allow at least 5
minutes for the Fuser to cool before removing the Fuser.
Applicable Chain Link
Chain Link
Initial Actions
Check the Fuser life using CentreWare IS.
Cycle printer power.
If problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Fuser, PL6.1.10
MCU Board, PL9.1.20
Troubleshooting Procedure Table
Step Actions and Questions
1. Check the Fuser life using CentreWare IS.
1
2. Does the Level show 0%?
1. Check the Fuser for correction
2
installation.
2. Is the Fuser correctly installed?
Does the error still occur?
3
4 1. Replace the Fuser (page 8-11).
2. Does the error still occur?
010-421: IOT Fuser Life Pre Warning
Wiring and Plug/Jack Map References
"Map 1 - Electrical and Drive" on
page 10-9
"Map 4 - LVPS and MCU Boards" on
page 10-12
"Fuser" on page 10-35
Error Messages and Codes
Yes No
Replace the Go to step 2.
Fuser
(page 8-11).
Go to step 3. Reseat the
Fuser
(page 8-11).
Go to step 3.
Go to step 3. Complete.
Replace the Complete.
MCU Board
(page 8-86).
3-57