Panasonic DP-MB500 series Operating Instructions Manual page 81

3.
For 2-line LCD models:
1. Select a scanning mode.
2. Select a destination.
For touch panel models:
1. Select the destination and scanning mode if necessary.
Note
• When scanning to email address, you can enter the destination email address
– see page 59 for character entry.
– pressing the desired station key (1-3).
– pressing
*1 One-touch dial equipped models only (
If the LDAP setting is activated beforehand (page 131), select "LDAP SEARCH" or "ADDRESS
OK/SET
BOOK".
For LDAP search, enter the name using the dial keypad (up to 11 characters), then press
OK/SET /
4.
If necessary, select the desired binding of the original.
1. : /DUPLEX /
2. Select the desired binding of the original.
5.
If necessary, change the scanning settings.
Select the desired setting.
• If you select "PASSWORD PDF" as the file format, enter a 4-digit password using dial keypad (page 59).
6.
/START
When using the scanner glass, scan the 1st page.
: To scan the next page, place the document and press OK/SET . Repeat this until all the
documents are scanned, then press
: To scan the next page, place the document and press "Scan". Repeat this until all the documents
are scanned, then press "Start".
7.
After you finish scanning, press
procedures.
*1
For 2-line LCD models only. (
When using the documents of same width but of different lengths (automatic document feeder only) (
Make sure that the following settings are activated in step 5 on "6.2 Scanning from the unit (Push Scan)".
– The scanning mixed size setting is ON.
– The scan size setting is set to the larger document size.
Available formats for scan image save
Scanning mode
*2
"VIEWER"
*2
"FILE"
"EMAIL" *2
*2
"OCR"
*2
"CLOUD"
OK/SET
OK/SET
*1
/LOWER , then press the desired station key (4-6).
*1
: "OK" to start searching.
: "DUPLEX"
OK/SET *1
/START .
: /STOP /
)
TIFF JPEG
6.2 Scanning from the unit (Push Scan)
*1
)
OK/SET
*1
: to reset the setting you set in these
BMP PDF *1
―
―
:
)
Operating Instructions 81