Fabrication Of Mc1.5-W-L Cable; Fabrication Of Mpyc-12 Cable; How To Connect Wires To The Wago Connector - Furuno VR-7000 Installation Manual

APPENDIX 2 CABLE FABRICATION

Fabrication of MC1.5-W-L cable

Shield Shield Shield
Vinyl tape Vinyl tape Vinyl tape
(fold back) (fold back) (fold back)
10 10 10
20 20 20
Fabrication of MPYC-12 cable (MC-3020D)
80 or more 80 or more 80 or more
No use: 50 No use: 50 No use: 50
(Wind vinyl tape to insulate.) (Wind vinyl tape to insulate.) (Wind vinyl tape to insulate.)

How to connect wires to the WAGO connector

Press downward.
Terminal opener
Wire WAGO connector
Twist
The terminal opener is preattached inside of the DCU. See the figure below.
DCU (cover removed)
You can use the slotted head screwdriver instead of the terminal opener.
AP-4
Core: 6 Core: 6 Core: 6
L1 L1 L1
135 135 135
95 95 95
Core: 6 Core: 6 Core: 6
<Procedure>
1. Twist the cores.
2. Press the terminal opener downward.
3. Insert the wire to hole.
4. Remove the terminal opener.
5. Pull the wire to confirm that it is secure.
Terminal opener