Cable Fabrication - Furuno FCV30BB Installation Manual

2.2

Cable Fabrication

LAN cable
The LAN cable (FR-FTPC-CY 10, 20, or 30 m) connects between the processor unit and
the transceiver unit. Cut armor and outer vinyl sheath as shown below and then connect the
modular connector MPS588-C (supplied) to both ends.
225
Inner vinyl sheath
TRANSCEIVER
UNIT SIDE
1
Expose inner vinyl sheath.
4
approx. 9mm
Fold back drain wire and
cut it, leaving 9 mm.
7
Using special crimping tool
MPT5-8 (PANDUIT CORP.),
crimp the modular plug.
Finally check the plug visually.
30
Outer vinyl sheath
Armor
(Clamp by the cable clamp.)
Wrap vinyl tape.
2
25mm
Remove the outer sheath by
approx 25 mm. Be careful
not to damage inner shield
and cores.
5
approx. 11mm
Straighten and flatten the
core in order and cut then,
leaving 11 mm.
WHT/GRN WHT/ORG
GRN
WHT/ORG WHT/GRN
BLU
WHT/BLE WHT/BLE
ORG
WHT/BRN WHT/BRN
BRN
11
150
Inner vinyl sheath
PROCESSOR
UNIT SIDE
3
approx. 9mm
Fold back the shield, wrap it
onto the outer sheath and
cut it, leaving 9 mm.
6
Insert the cable into the modular
plug so that the folded part of
the shield enters into the plug
housing. The drain wire should
be located on the tab side of
the jack.
ORG
BLU
GRN
BRN
2. WIRING
Drain wire