Table of Contents
Advertisement
1.6
Control Unit FAP-7021
The Handheld Control Unit FAP-7021 can be mounted on the bulkhead or desktop using
the cradle.
When selecting a location for the Control Unit, keep the following in mind.
• Mount the unit where shock and vibration are minimal.
• Do not install the display unit under "Plexiglas" or other type of shielding material. Plexi-
glas can trap heat and moisture or magnify sunlight energy onto the surface of the dis-
play.
• Follow the compass safe distances shown in the safety instructions on page i to pre-
vent interference to a magnetic compass.
For the cradle mount, fix the cradle to the mounting location with four self-tapping screws
(4x20, supplied), referring to the outline drawing for mounting dimensions. Put the Control
Unit in the cradle.
1.7
Cable Extension Kit FAP-7822 (option)
The Control Unit FAP-7021 comes with a 10 m cable. If the cable is not long enough, use
the Cable Extension Kit FAP-7822, which provides for extension of the cable an additional
10 m.
Type: Cable Extension Kit FAP-7822 Code No.: 001-082-780
Name
Connector fixing box 64-027-1011-2
Label
Self-tapping screw
Cable
Fix the Connector Fixing Box with four self-tapping screws (4x20, supplied). Refer to the
outline drawing for mounting dimensions.
Note 1: When the Control Unit is not connected, attach the terminator (supplied) to the
Connector Fixing Box.
Note 2: To connect the extension cable to the Processor Unit, remove the connector.
Type
64-027-1012-1
4x20
BD-07PM-07AF-LR-100
Code No.
100-327-882-10
100-327-891-10
000-158-850-10
000-172-016-10
1. INSTALLATION
Qty
1
1
4
1
1-13
Advertisement
Table of Contents
