Furuno VR-7000 Installation Manual page 23

Mounting
The microphone is designed to be flush-mounted.
1. Make a mounting hole in the mounting location and prepare four pilot holes, refer-
ring to the outline drawing at the back of this manual.
2. Remove four binding screws to detach the back cover of the unit.
3. Pass the cable through the mounting hole made at step 1.
4. Connect the cable to the unit. For details of connection and wiring, section 2.5 and
interconnection diagram at the back of this manual.
5. After wiring, attach the back cover to the unit with four binding screws.
6. Set the unit to the mounting hole, then fix the unit with four self-tapping screws
(supplied).
Self-tapping screw
(4 pcs)
Binding screw
(4 pcs)
Back cover
Bulkhead Bulkhead
1. MOUNTING
1-15