Video Lan Converter Mounting - Furuno VR-7000 Installation Manual

1. MOUNTING
1.7 Video LAN Converter IF-7100
Mounting considerations
Select a mounting location, keeping in mind the following points:
• Locate the unit away from heat sources.
• Select a location where the shock and vibration are minimal.
• Locate the unit away from places subject to water splash and rain.
• Make the maintenance space shown in the outline drawing for maintenance and
checking purpose.
• A magnetic compass will be affected if the unit is placed too close to the magnetic
compass. Observe the compass safe distances at the front of this manual to prevent
interference to a magnetic compass.
• Select a mounting location considering the length of the cables to be connected to
this unit.
• For the bulkhead mounting, the cable entrance of the unit should face downward.
• Select the cable length of the DVI cable considering the resolution of the radar/EC-
DIS display.
SXGA or below: less than 10 m
UXGA or higher: less than 5 m
• Use the optional cable shown below to input the DVI-D or RGB signal.
• DVI-D:
• RGB:
Mounting
The video LAN converter can be mounted on the floor, or on a bulkhead.
Fasten the unit with four hex. bolts (M8x25), spring washer, flat washer, and hex. nut.
The installation materials are supplied with the IF-7100.
Spring washer Spring washer
Flat washer Flat washer
1-22
DVI-D/D S-LINK 5M/10M
BNCX5-DSUB15-L400 and CP24-01200/01210 (see section 2.7.2), or
3COX-2P-6C 5M/10M
Hex. bolt Hex. bolt
Hex. nut Hex. nut