Connection With A Furuno Radar - Furuno VR-7000 Installation Manual

2. WIRING
4. Fix the armor of the power cable to the cable clamp, using the supplied cable tie.
5. Attach the supplied rod terminal (type: A1.5-10) to the signal cores for connection
to the J1 port.
6. Connect the cores to the connector that is pre-inserted at the J1 port.
7. Fold the excess cable (inside the unit), then fix the excess cable at the cable sad-
dle indicated in the figure below.
Note: The cable length between the cable saddle and J1 port should be as short
as possible. Also, route the cables so that they do not make contact with the ar-
mor.
Fold the cables inside the Fold the cables inside the
unit, then fix them with the unit, then fix them with the
cable saddle. cable saddle.
8. Reattach the chassis cover.
9. Connect the DVI-D, RGB, and LAN cables.
10. Fix the LAN cable to the cable clamp with the supplied cable tie.
11. Reattach the outside cover.
2.7.4

Connection with a FURUNO radar

Connection with the FAR-217/FAR-287 series radar
For the connection between the IF-7100 and FAR-217/FAR-287 series radar, see
the respective radar installation manual.
Note: When the FAR-287 series radar is connected to the IF-7100, set the DIP
switch inside the unit (see section 3.3).
2-22
Cable saddle Cable saddle
J1 port J1 port
Fuse: Fuse:
Places at the bottom left of Places at the bottom left of
the J1 port. the J1 port.
Type: FGMB 125V 2A PBF Type: FGMB 125V 2A PBF
J1 port J1 port
Cable clamp
Cable tie Cable tie