Furuno VR-7000 Installation Manual page 29

4. Fabricate the cable.
Armor Sheath Sheath
Cable jacket Cable jacket
30 30
5. Pass the cable through the nut and cable entrance.
6. Wrap the vinyl tape and cable tie around the cable (see the figure below).
Cable jacket Cable jacket
Cable tie:
Wrap around the vinyl tape.
7. Connect the cable to the unit. For details, see section 2.6 and the interconnection
diagram at the back of this manual.
8. After wiring, fasten the nut so the clearance between it and the gland is 3 mm or
less (see figure below).
9. Fasten the front panel to the waterproof cover with the four binding screws re-
moved at step 1.
Note 1: Before fixing the front panel, make sure the waterproofing gasket is cor-
rectly seated in the groove in the waterproof cover.
Note 2: Take care not to bend or pinch the cable.
Aluminum tape
(Cut the drain wire.)
170
5
Armor
Vinyl tape
6
3 mm or less
1. MOUNTING
1-21