Recording Expiration Date Of The Battery And Hydrostatic Release Unit; Battery In The Float-Free Dru - Furuno VR-7000 Installation Manual

1. MOUNTING
4. Confirm the following points;
• There is no space or foreign material between the storage module and docking
module.
• The notch on the docking module is placed in the groove of the storage module.
OK
WRONG
• The antenna of the capsule is placed in the antenna holder correctly.
5. Reattach the cover and snap pin to the mounting bracket.
Recording the expiration date of the battery and hydrostatic release unit
After installing the float-free DRU, confirm the expiration date of the battery (inside the
float-free DRU (capsule)) and hydrostatic release unit, then record them to the table
in section 3.2. The expiration date is recorded during coding (see page AP-31).

• Battery in the float-free DRU

The expiration date of the battery is indicated on the sticker attached to the side of
the capsule. According to the expiration date, the numbers on the sticker are cut out
or filled with a permanent marker. For example, when the expiration date is April
2019, "2019" and "4" on the sticker are cut out or filled with a permanent marker.
After confirming the expiration date, record it to the table in section 3.2.
1-8
The notch on the docking module is placed
in the groove of the storage module.
No space or foreign material between the
storage module and docking module.
The notch on the docking module is not
placed in the groove of the storage
module.
There is space between the storage
module and docking module.
Antenna holder
Capsule:
The battery is built-in.
Hydrostatic release unit
Bracket