Intelligent Hub Hub-3000; Power Supply Unit Psu-011 - Furuno VR-7000 Installation Manual

2. WIRING
2.9

Intelligent HUB HUB-3000

Fix the LAN cable connected to the cable clamp using the cable ties (supplied).
LAN cable
2.10

Power Supply Unit PSU-011

For wiring details, refer to the interconnection diagram at the back of this manual.
1. Unfasten the cable clamp.
2. Remove four screws to remove the cover from the unit.
3. Attach the crimp-on lugs (FV2-4, supplied) to the power cable, then connect be-
tween the PSU-011 and J1 port on the DCU.
4. Attach the crimp-on lugs (FV2-4, supplied) to the power cable, then connect be-
tween the PSU-011 and power source.
5. Fasten the cable clamp, then reattach the cover.
2-40
DPYC-1.5 cable
No use.
LAN port to network equipment
Attach the LAN port cap (supplied) to the unused connector
holes to provide waterproofing standard IPX2.
Cable clamp
Power port
Power Fail
DPYC-1.5 cable
Ground wire
(IV-1.25sq., supplied)