How To Set Up The Fe-800 For Data Recording; How To Set Draught From External Equipment - Furuno FE-800 Operator's Manual

2.11

How to Set Up the FE-800 for Data Recording

The following setup procedure is required before using the optional data recording software.
1. Press the MENU/ESC key to open the Main menu.
2. Select [System] using  or , then press the ENT key.
3. Select [Data Recorder] using  or , then press the ENT key.
4. Select [DEST IP Address] using  or , then press the ENT key. This will open a pop-up
window to set the IP address of the connected PC.
The available setting range is [000.000.000.000] to [255.255.255.255].
Note: Do not use the following IP range: [239.192.000.001] to [239.192.000.064].
5. Press  to increase or  to reduce the value of the highlighted digit. Press  or  to select
a digit to set. To complete the setting process for the IP address, press  until the cursor
passes the final digit.
6. Select [DEST Port] using  or , then press the ENT key. A pop-up window to set the
destination port on the connected PC appears.
The available setting range is [00000] to [65535].
7. Press  to increase or  to reduce the value of the highlighted digit. Press  or  to select
a digit to set. To complete the setting process for the Port, press  until the cursor passes the
final digit.
8. Press the DISP key to close the menu.
2.12

How to Set Draught from External Equipment

To use the draught value from external equipment, do the following:
1. Press the MENU/ESC key to open the Main menu.
2. Select [System] using  or , then press the ENT key.
3. Select [EXT Setting] using  or , then press the ENT key.
4. Select [ON]  or , then press the ENT key.
5. Press the [DISP] to close the menu.
34
2. SYSTEM MENU