Removing/Installing The Power Inlet; Removing; Installing - Invacare HomeFill II Service Manual

Removing/Installing the Power Inlet

NOTE: For this procedure, refer to FIGURE 7.2.
Tools required for this procedure are:
• Phillips screwdriver,
• Torque Wrench

Removing

1. Remove the cabinet. Refer to Removing/Installing the Cabinet on page 21.
2. Remove the two mounting screws that secure the power inlet to the base.
3. Slowly pull the power inlet out of the base assembly to expose the wire connections.
4. Note the location of the wire connector and dual terminal connector before
disconnecting the wire connectors from the power inlet.
NOTE: The dual terminal connector houses the top and middle wire connectors.
5. Disconnect the bottom wire connector from the power inlet.
6. Disconnect the dual terminal connector from the power inlet.
7. Discard the existing power inlet.

Installing

1. Connect the dual terminal connector to the new power inlet.
2. Connect the bottom terminal connector to the new power inlet.
3. Secure the power inlet to the base with two mounting screws. Torque the mounting
screws to 20–25 inch-pounds.
4. Install the cabinet. Refer to Removing/Installing the Cabinet on page 21.
NOTE: Top and Middle
wire connectors attach
to dual termnial
connector.
Part No 1141487
Top Wire
Connector
Middle Wire
Connector
Bottom Wire
Connectors
FIGURE 7.2 Removing/Installing the Power Inlet
SECTION 7—BASE COMPONENTS
Power Inlet
33
Base
Mounting Screws
HomeFill™II Compressor