Invacare HomeFill II Service Manual page 17

GREEN Dots
5. Grasp the cylinder/regulator assembly in the area behind the cylinder gauge in
FIGURE 4.2 on page 18.
6. Position the cylinder in the compressor cradle (Detail "A" of FIGURE 4.2).
7. Align the cylinder fillport with the connector fillport (Detail "B" of FIGURE 4.2).
8. Pull up on the outer ring (sleeve) of the connector fillport while pushing down on the
cylinder/regulator assembly to couple the cylinder fillport into the connector fillport
(Detail "A" of FIGURE 4.2).
NOTE: The cylinder is properly connected when an audible "click" is heard.
Part No 1141487
PUSH Outer Ring (Sleeve)
DOWN
BEFORE
COUPLING
CYLINDER,
PUSH DOWN
GREEN DOTS
ARE VISIBLE.
FIGURE 4.1 Resetting Connector Fillport
SECTION 4—COMPRESSOR OPERATION
Connector Fillport
ON SLEEVE
UNTIL
17
HomeFill™II Compressor