Machine Default - Kyocera KM-2530 Service Manual

(4) Machine default

Auto drawer switching
Sets whether the auto drawer switching function
is available.
1. Select "Auto cassette switching" and press
the [Change #] key.
2. Select "On" or "Off".
Special paper
Sets the drawer for such special paper as colored
paper or recycled paper.
1. Select "Special paper" and press the [Change
#] key.
2. Select "1st paper" or "2nd paper".
APS for special paper
Sets whether to use the paper source with the
special paper for auto paper selection and auto
drawer switching.
1. Selct "APS for special paper" and press the
[Change #] key.
2. Select "On" or "Off".
Paper size (upper drawer)
Sets the paper size for upper drawer.
1. Select "Paper size (1st cassette)" and press
the [Change #] key.
2. Select the paper size.
Paper size (lower drawer)
Sets the paper size for lower drawer.
1. Select "Paper size (2nd cassette)" and press
the [Change #] key.
2. Select the paper size.
Paper type (upper drawer)
Sets the paper type (standard or special) for
upper drawer.
1. Select "Paper type (1st cassette)" and press
the [Change #] key.
2. Select the paper type.
Paper type (lower drawer)
Sets the paper type (standard or special) for
lower drawer.
1. Select "Paper type (2nd cassette)" and press
the [Change #] key.
2. Select the paper type.
Check bypass sizing
Sets whether or not to display the paper size key
of the basic screen when copying with the bypass
tray.
1.Select "Check bypass express" and press the
[Change #] key.
2. Selct "On" or "Off".
Auto shutoff time
Sets the auto shutoff time.
1. Select "Auto shut-off time" and press the
[Change #] key.
2. Press the +/- keys to set the auto shutoff
time.
Setting range: 15 to 240 minutes
Auto preheat time
Sets the auto preheat time.
1. Select "Auto preheat time" and press the
[Change #] key.
2. Press the +/- keys to set the auto preheat
time.
Setting range: 1 to 45 minutes
Note: Set the auto preheat time to be shorter
than the auto shutoff time.
Copy eject location setting
Selects whether to eject copies to copier, finisher
or job separator.
1. Select "Select Copy output mode" and press
the [Change #] key.
2. Select the eject location.
Key sound
Sets if a beep sounds when a key on the key
press panel is pressed.
1. Select "Key sound ON/OFF" and press the
[Change #] key.
2. Select "On" or "Off".
Silent mode
Selects whether or not to enter silent mode after
copying.
1. Select "Silent Mode" and press the [Change
#] key.
2. Select "On" or "Off".
Management code change
Changes the management code.
1. Select "Management code change" and press
the [Change #] key.
2. Enter the 4-digit management code using the
numeric keys and press the enter key.
Auto shutoff
Sets whether the auto shutoff function is
available.
1. Select "Auto shut-off" and press the [Change
#] key.
2. Select "On" or "Off".
2DF
1-3-13