Kyocera KM-2530 Service Manual page 46

2DF
7. Remove the two screws securing the shield
cover and then the cover.
8. Detach the 10-pin connector (four wires) from
CN4 on the main PCB and connect it to J2 on
the IPC PCB.
10-pin connector
9. Connect J1 on the IPC PCB to CN15 on the
main PCB.
10. Insert the three board supports of the IPC
PCB into the main PCB to secure them.
11. Refit the shield cover.
1-3-26
IPC PCB
J2
IPC PCB
Screws
Main PCB
Main PCB
Figure 1-3-40
CN15
CN4
10-pin connector
Figure 1-3-41
CN15
J1
Board support
IPC PCB
Figure 1-3-42
Shield cover
Board
supports