Kyocera KM-2530 Service Manual page 66

2DF
Install the (optional) hard disk.
5. Remove 2 screws and take off the cover.
6. Push the hard disk all the way in along the
rails, and fasten it with 2 screws.
Installing the Optional Bar-Code Reader
7. Fasten the serial connector in place with 2
screws.
8. Tie the excess cord with the two bands, so
that the free cord length comes to about 1
meter.
9. Peel off the backing from one of the clamps,
adhere the clamp to the copier at the position
shown in the illustration, and pass the wire
though the clamp.
• If a wing tray is installed, attach the other
clamp to the wing tray and pass the wire
through both clamps.
Installing the Optional Memory DIMM
10. Remove the printing system, and insert the
optional memory DIMM firmly into either of
the memory slots. Push the DIMM firmly into
the slot so that the two hooks (one hook at
each end of the slot) snap closed.
• The board provides two DIMM slots, and can
accept up to two optional DIMMs. If installing
a single DIMM, you can use either slot.
1-3-44
Cover
Screws
Figure 1-3-90
Clamp
Bands
Figure 1-3-91
Option mermory
DIMM
Hooks
Figure 1-3-92
Hard desk
Screws
Wing tray
Cramps
Serial connector
Screws
Memory
slots
Hooks