Kärcher KM 120/150 R Bp Pack User Manual page 29

Figure 12
Once the required height has been
reached:
Tip waste container out. Press button 1
(operator console) and 5 simultaneous-
ly.
Tip waste container back in. Press but-
ton 1 (operator console) and 4 simulta-
neously.
Lower waste container. Press button 1
(operator console) and 3 simultaneous-
ly.
Note
The container can only be fully retracted if
it is tipped back into its starting position be-
forehand. In such a case, the symbol
"Waste container not tipped" on the control
console glows red.
Shutting down
Set programme switch to step 1 (driv-
ing). The side brush and roller brush are
raised.
Turn main key to "0" and remove it.
Note
Once the machine has been switched off,
the dust filter is shaken automatically for
approx. 15 seconds. The display remains
activated during this period.
Transport
Danger
Risk of injury! When loading or unloading
the machine, it may only be operated on
gradients of max. 10%. Drive slowly.
Turn main key to "0" and remove it.
When transporting in vehicles, secure the
appliance according to the guidelines from
slipping and tipping over.
Secure the wheels of the machine with
wheel chocks.
Secure the machine with tensioning
straps or cables.
Figure 13
Caution
Observe markings for fixing points on base
frame (chain symbols).
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
Shutdown
If the sweeper is going to be out of service
for a longer time period, observe the follow-
ing points:
Park the sweeper on an even surface.
Set programme switch to step 1 (driv-
ing). The roller brush and side brushes
are raised to prevent the bristles being
damaged.
Turn main key to "0" and remove it.
Lock the sweeper to ensure that it does
not roll off.
Clean the inside and outside of the
sweeper.
Warning
Danger of damage to the machine because
of water penetrating into the machine! The
machine should not be sprayed using a
high pressure water jet.
Park the machine in a safe and dry
place.
Disconnect battery.
Charge battery and recharge it approx.
every 2 months.
Storing the device
This appliance must only be stored in inte-
rior rooms.
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
Maintenance and care
Cleaning the inside of the machine
Danger
Risk of injury! Wear dust mask and protec-
tive goggles.
Open cover and secure it (Diag. 3).
Clean machine with a cloth.
Blow through machine with com-
pressed air.
Close cover.
External cleaning of the appliance
Clean the machine with a damp cloth
which has been soaked in mild deter-
gent.
Note
Do not use aggressive cleaning agents.
Maintenance intervals
Note
The elapsed-time counter shows the timing
of the maintenance intervals.
Maintenance by the customer
Daily maintenance:
Check the sweeping roller and the side
brush for wear and wrapped belts.
Check function of all operator control el-
ements.
Weekly maintenance:
Check fluid level of battery.
10
-
EN
Check dust filter for sweeping system.
Check hydraulic lines for leaks.
Check moving parts for freedom of
movement.
Check the sealing strips in the sweep-
ing area for position and wear.
Maintenance to be carried out every 100
operating hours:
Check function of seat contact mat.
Check tension, wear and function of
drive belts (V-belt and circular belt).
Maintenance following wear:
Replace sealing strips.
Replace roller brush.
Replace side brush.
Note
For description, see section on Mainte-
nance work.
Note
Where maintenance is carried out by the
customer, all service and maintenance
work must be undertaken by a qualified
specialist. If required, a specialised Kärch-
er dealer may be contacted at any time.
Maintenance by Customer Service
Maintenance to be carried out after 20 op-
erating hours:
Carry out initial inspection.
Maintenance to be carried out every 100
operating hours
Maintenance to be carried out every 200
operating hours
Maintenance to be carried out every 300
operating hours
Note
In order to safeguard warranty claims, all
service and maintenance work during the
warranty period must be carried out by the
authorised Kärcher Customer Service in
accordance with the maintenance booklet.
Maintenance Works
Preparation:
Park the sweeper on an even surface.
Turn main key to "0" and remove it.
Press emergency-stop button.
General notes on safety
Danger
Risk of injury! While working around the lift/
tilt emptying mechanism, raise the waste
container to its highest point and secure.
Figure 14
Insert safety support into the piston rod
for the lifting cylinder and secure it.
29