Changing Lanesense Status; Rear Back Up Camera - If Equipped - Jeep RENEGADE 2017 Owner's Manual

Hide thumbs Also See for RENEGADE 2017:
Table of Contents

Advertisement

• For example: If approaching the left side of the lane the
steering wheel will turn to the right.
Lane Approached (Flashing Yellow Thick Line, Solid
Yellow Thin Line/Flashing Yellow Telltale)
NOTE: The LaneSense system operates with the similar
behavior for a right lane departure.

Changing LaneSense Status

The LaneSense system has settings to adjust the intensity of
the torque warning and the warning zone sensitivity
(early/late) that you can configure through the Uconnect
system screen. Refer to "Uconnect Settings" in "Multime-
dia" for further information.
NOTE:
• When enabled the system operates above 37 mph
(60 km/h) and below 112 mph (180 km/h).
• Use of the turn signal suppresses the warnings.
• The system will not apply torque to the steering wheel
whenever a safety system engages. (anti-lock brakes,
traction control system, electronic stability control, for-
ward collision warning, etc.).
REAR BACK UP CAMERA — IF EQUIPPED
The Rear Back Up Camera allows you to see an on-screen
image of your vehicle's rear surroundings when the gear
selector is put into REVERSE. The image will be displayed
on the touchscreen display along with a note to "Check
Entire Surroundings" across the top of the screen. After five
seconds, this note will disappear. The camera is located
above the rear license plate.
STARTING AND OPERATING 285
6

Advertisement

Table of Contents
loading

Table of Contents