Table of Contents
Advertisement
Enhanced Accident Response System Reset
Procedure
After the event occurs, when the system is active, a
message regarding fuel cutoff is displayed. Turn the igni-
tion switch from ignition AVV/START or MAR/ACC/
ON/RUN to ignition STOP/OFF/LOCK. Carefully check
the vehicle for fuel leaks in the engine compartment and on
the ground near the engine compartment and fuel tank
before resetting the system and starting the engine.
Depending on the nature of the event the left and right turn
signal lights, located in the instrument panel, may both be
blinking and will continue to blink. In order to move your
vehicle to the side of the road, you must follow the system
reset procedure.
Customer Action
NOTE: Each step MUST BE held for at least two sec-
onds
1. Turn ignition STOP/
OFF/LOCK. (Turn Signal
Must be placed in Neutral
State).
2. Turn ignition MAR/
Customer Will See
Right turn light BLINKS.
Customer Action
NOTE: Each step MUST BE held for at least two sec-
onds
ACC/ON/RUN.
3. Turn right turn signal
switch ON.
4. Place turn signal in
neutral state.
5. Turn left turn signal
switch ON.
6. Place turn signal in
neutral state.
7. Turn right turn signal
switch ON.
8. Place turn signal in
neutral state.
9. Turn left turn signal
switch ON.
SAFETY
225
Customer Will See
Left turn light is OFF.
Right turn light is ON
SOLID.
Left turn light BLINKS.
Right turn light is OFF.
Left turn light BLINKS.
Right turn light BLINKS.
Left turn light is ON
SOLID.
Right turn light BLINKS.
Left turn light is OFF.
Right turn light is ON
SOLID.
Left turn light BLINKS.
Right turn light is OFF.
Left turn light BLINKS
Right turn light is ON
SOLID.
Left turn light is ON
5
Advertisement
Table of Contents
