Table of Contents
Advertisement
DISABLED" for approximately five seconds. Refer to "In-
strument Cluster Display" in "Getting To Know Your
Instrument Panel" for further information.
The Rear ParkSense switch LED will be on when Rear
ParkSense is disabled or requires service. The Rear
ParkSense switch LED will be off when the system is
enabled. If the Rear ParkSense switch is pushed, and
requires service, the Rear ParkSense switch LED will blink
momentarily, and then the LED will be on.
Rear ParkSense will remember the previous state when the
vehicle is switch off.
CAUTION!
After turning OFF the ignition, the Rear ParkSense
remains in this setting until the next ignition cycle,
even in the case of changing the setting of starting
RUN to OFF and then again in RUN.
Service The Rear ParkSense System
During vehicle start up, when the Rear ParkSense System
has detected a faulted condition, the instrument cluster
will actuate a single chime, once per ignition cycle, and it
will display a message such as "PARKSENSE UNAVAIL-
ABLE WIPE REAR SENSORS" or the "PARKSENSE UN-
AVAILABLE SERVICE REQUIRED". Refer to "Instrument
Cluster Display" for further information. When the gear
selector is moved to REVERSE and the system has detected
a faulted condition, the instrument cluster display will
show a message such as PARKSENSE UNAVAILABLE
WIPE REAR SENSORS or PARKSENSE UNAVAILABLE
SERVICE REQUIRED for approximately five seconds.
Under this condition, Rear ParkSense will not operate.
If "PARKSENSE UNAVAILABLE WIPE REAR SENSORS"
appears in the instrument cluster display, make sure the
outer surface and the underside of the rear fascia/bumper
is clean and clear of snow, ice, mud, dirt or other obstruc-
tions and then cycle the ignition. if the message continues
to appear, see an authorized dealer.
If "PARKSENSE UNAVAILABLE SERVICE REQUIRED"
appears in the instrument cluster display, see an autho-
rized dealer.
STARTING AND OPERATING 277
6
Advertisement
Table of Contents
