Operation Switch; Auto-Reverse Feature; Removing And Installing Panels; Removing Panels - Jeep RENEGADE 2017 Owner's Manual

Operation Switch

1 — Front Panel Open/Close Switch
2 — Front Panel Vent Switch
To retract the front panel to the open position, push the
open/close button.
From the fully open position, pull the open/close switch:
the front panel will close completely.
Venting The Front Panel
To vent the front panel push and release the vent switch.
GETTING TO KNOW YOUR VEHICLE 87
During the vent operation any push on the open/close
switch will stop the closing of the panel.
NOTE: If the My Sky is in open position, the vent switch
must be held until the panel vents.

Auto-Reverse Feature

The front panel of the retractable roof is equipped with a
auto-reverse safety system that is able to detect the pres-
ence of an obstacle during the opening and closing motion
of the panel.
When this event occurs, the front panel stops and reverses
immediately.
NOTE: With both panels removed the retractable roof
cannot be opened or closed.

Removing And Installing Panels

NOTE:
• Remove the panels only when the vehicle is stationary.
• The rear panel can be removed only when the front
panel is completely closed or removed.

Removing Panels

1. Front panel must be in the closed position to remove
panels.
3