Specifying The Machine Settings - Minolta DI1610F User Manual

7.2 Specifying the Machine Settings

7.2 Specifying the Machine Settings
From the "MACHINE SETTING" menu, various settings for the machine's operating
environment can be specified. Refer to the following table for details on each
function.
No. Name
1 AUTO PANEL RESET
2 ENERGY SAVE MODE
3 DENSITY (ADF)
4 DENSITY (BOOK)
5 PRINT DENSITY
6 LCD CONTRAST
7 LANGUAGE
8 LAMP OFF TIME
9 BUZZER VOLUME
0 INITIAL MODE
Di1610f
Description
Whether the Auto Panel Reset function is disable or the time (0.5 min,
1 min, 2 min, 3 min, 4 min, or 5 min) until the machine is reset after
finishing copying/printing or after performing the last operation can be
selected. If the Auto Panel Reset function is enabled, all functions are
automatically reset to their default settings.
• The factory default setting is 1 min.
If the machine performs no operations for a set length of time, it will
automatically enter the Energy Save mode. The length of time until the
machine enters Energy Save mode can be set between 1 and 240 min
(in 1 min increments).
• The factory default setting is 15 min.
The scanning density when using the Auto Document Feeder can be
adjusted.
Mode 1: For printing lighter copies of dark documents to avoid
darkening of copies.
Mode 2: For printing copies with same density as documents.
• The factory default setting is "Mode 1".
The density when scanning from the Original Glass can be adjusted.
Mode 1: For printing copies with same density as documents.
Mode 2: For printing lighter copies of dark documents to avoid
darkening of copies.
• The factory default setting is "Mode 1".
The copy/print density can be adjusted to one of six levels between
–3 and +2. With the normal print density at 0, choose a smaller number
for a lighter print or choose a higher number for a darker print.
• The factory default setting is "0" (Normal).
The brightness of the display can be set to one of four levels between
–1 and +2.
• The factory default setting is "0" (Normal).
The display language can be selected.
• The factory default setting is "English".
The time until the exposure lamp goes off can be adjusted.
Mode 1: When four hours have passed since the last operation was
performed
Mode 2: When the machine enters Energy Save mode
• The factory default setting is "Mode 1".
This function can be used to set the volume of alarms and the beep
sounded when a key is pressed.
• The manufacturer's default setting is "LOW".
This function can be used to set the mode (Copy mode or Fax mode)
that the machine starts up in or returns to after the Control Panel is
reset.
• The manufacturer's default setting is "COPY".
7
7-3