Cisco ASA 5505 Configuration Manual page 347

Adding a StandardACL
This chapter describes how to configure a standard ACL and includes the following sections:
•
•
•
•
•
•
Information About Standard ACLs
Standard access lists identify the destination IP addresses of OSPF routes and can be used in a route map
for OSPF redistribution. Standard access lists cannot be applied to interfaces to control traffic.
Licensing Requirements for Standard ACLs
The following table shows the licensing requirements for this feature:
Model License Requirement
All models Base License.
Guidelines and Limitations
This section includes the guidelines and limitations for this feature:
•
•
•
•
OL-20339-01
Information About Standard ACLs, page 17-1
Licensing Requirements for Standard ACLs, page 17-1
Guidelines and Limitations, page 17-1
Default Settings, page 17-2
Adding Standard ACLs, page 17-2
Feature History for Standard ACLs, page 17-4
Context Mode Guidelines, page 17-2
Firewall Mode Guidelines, page 17-2
IPv6 Guidelines, page 17-2
Additional Guidelines and Limitations, page 17-2
C H A P T E R
Cisco ASA 5500 Series Configuration Guide using ASDM
17
17-1