Cisco ASA 5505 Configuration Manual page 426

Customizing EIGRP
•
•
•
Click OK.
Step 6
Click the Networks tab.
Step 7
Click Add to add a new network entry.
Step 8
The Add EIGRP Network dialog box appears. To remove a network entry, choose the entry in the table
and click Delete.
Choose the AS number of the EIGRP routing process from the drop-down list.
Step 9
Enter the IP address of the networks to participate in the EIGRP routing process in the IP Address field.
Step 10
To change a network entry, you must first remove the entry and then add a new one. You cannot edit
Note
existing entries.
Enter a network mask to apply to the IP address in the Network Mask field.
Step 11
Click OK.
Step 12
Customizing EIGRP
This section describes how to customize the EIGRP routing and includes the following topics:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Cisco ASA 5500 Series Configuration Guide using ASDM
23-6
Stub Static—Advertises static routes.
Stub Redistributed—Advertises redistributed routes.
Stub Summary—Advertises summary routes.
Defining a Network for an EIGRP Routing Process, page 23-7
Configuring Interfaces for EIGRP, page 23-7
Configuring Passive Interfaces, page 23-8
Configuring the Summary Aggregate Addresses on Interfaces, page 23-9
Changing the Interface Delay Value, page 23-10
Enabling EIGRP Authentication on an Interface, page 23-10
Defining an EIGRP Neighbor, page 23-11
Redistributing Routes Into EIGRP, page 23-12
Filtering Networks in EIGRP, page 23-13
Customizing the EIGRP Hello Interval and Hold Time, page 23-15
Disabling Automatic Route Summarization, page 23-15
Configuring Default Information in EIGRP, page 23-16
Disabling EIGRP Split Horizon, page 23-17
Restarting the EIGRP Process, page 23-18
Chapter 23 Configuring EIGRP
OL-20339-01