Cisco ASA 5505 Configuration Manual page 438

Monitoring EIGRP
Restarting the EIGRP Process
To restart an EIGRP process or clear redistribution or counters, perform the following steps:
In the main ASDM window, choose Configuration > Device Setup > Routing > EIGRP > Setup.
Step 1
The EIGRP Setup pane appears.
Click Reset.
Step 2
Monitoring EIGRP
You can use the following commands to monitor the EIGRP routing process. For examples and
descriptions of the command output, see the Cisco ASA 5500 Series Command Reference. Additionally,
you can disable the logging of neighbor change messages and neighbor warning messages.
To monitor or disable various EIGRP routing statistics, perform the following steps:
In the main ASDM window, choose Monitoring > Routing > EIGRP Routing.
Step 1
Click the routes that you want to monitor.
Step 2
By default, neighbor change and neighbor warning messages are logged.
Note
Configuration Example for EIGRP
The following example shows how to enable and configure EIGRP with various optional processes:
In the main ASDM window, choose Configuration > Device Setup > Routing > EIGRP > Setup.
Step 1
The EIGRP Setup pane appears.
Check the Enable EIGRP routing check box.
Step 2
Click OK.
Step 3
Click the Passive Interfaces tab.
Step 4
Choose the interface you want to configure from the drop-down list.
Step 5
Check the Suppress routing updates on all interfaces check box to specify all interfaces as passive.
Step 6
Even if an interface is not shown in the Passive Interface table, it will be configured as passive when this
check box is selected.
Click Add to add a passive interface entry.
Step 7
The Add EIGRP Passive Interface dialog box appears. From here you can select the interface you want
to make passive in the dialog box. To remove a passive interface, select the interface in the table and
click Delete.
Cisco ASA 5500 Series Configuration Guide using ASDM
23-18
Chapter 23 Configuring EIGRP
OL-20339-01