Connecting An Edge Finder - HEIDENHAIN POSITIP 880 User Manual

The operator can setup any encoder input to go to any axis.
Default configuration:
Encoder input Mill
X1 X
X2 Y
X3 Z
X4 W
X5 U
X6 V

Connecting an Edge Finder

Connect the HEIDENHAIN Edge Finder to the D-sub input X10 on the
rear panel.
Adapt POSITIP 880 for use with the Edge Finder through the following
operating parameters:
Stylus length
Stylus diameter
Description of operating parameters see Job Setup chapter.
The operator must enter new edge finder settings.
Pin layout for Edge Finder input (see Fig. II.5 for pinout)
Pin Assignment
1 Internal shield
2 Stand-by
6 UP +5 V
8 UP 0V
13 Switch signal
Housing External shield
All other pins: not assigned
POSITIP 880
Turn
X
Z
Xo
Zo
A
Ao
Fig. II.4 Encoder inputs on rear panel.
Type
KT 130
KT 130
KT 130
KT 130
Fig. II.5 15 pin receptacle connector for Edge Finder
115