HEIDENHAIN POSITIP 880 User Manual page 33

PROBE 1ST POINT IN X/Y
Move edge finder towards first point
circumference until the LEDs on the edge finder light
up.
Retract edge finder from bore hole wall.
Probe two additional points on the circumference in
the same manner. Further instructions appear on the
screen. See Prompt bar for measured diameter.
ENTER CENTER POINT X
Enter the first coordinate (X = 50 mm) and
transfer coordinate as datum for the circle center and
press ENT.
ENTER CENTER POINT Y
Accept default entry Y = 0 mm. Press ENT. Press USE.
POSITIP 880
1 on the
X = 50
Y = 0
33