Tool Table Usage
Example: Entering the tool length and diameter into the tool
table. See Fig. I.62 & Fig. I.63.
Tool diameter 3.00
Tool length: 25.000
Tool unit: mm
Tool type: flat end mill
It is also possible to have POSITIP 880 determine an
offset. See alternative example below.
Press the INFO soft key, then the JOB SETUP soft key.
The cursor will default to the TOOL TABLE field.
Press ENT.
TOOL TABLE
Cursor to the tool you want to define or enter the tool
number. Press ENT.
TOOL DIAMETER
Enter the tool diameter (3.0) and
press ENT.
Cursor will automatically move to the LENGTH field.
POSITIP 880
Fig. I.62 Tool length and diameter entry
85