Installation Setup; Initial Switch-On; Ii – 2 Installation Setup - HEIDENHAIN POSITIP 880 User Manual

II – 2 Installation Setup

Initial switch-on

When you switch on power to your POSITIP 880 for the first time, the
screen shown in Fig. II.6 appears. You can now select the appropriate
language and the type of application (milling or turning).
Press LANGUAGE to scroll through the user interface languages.
For milling:
Press the MILL soft key.
For turning:
Press the TURN soft key.
POSITIP 880 automatically provides the functions appropriate to the
selected application.
You can change the application later in INSTALLATION SETUP under
COUNTER SETTINGS.
This section contains installation setup parameters. Installation setup
is accessed by pressing the INFO soft key, which brings up
INSTALLATION SETUP soft key. See Fig. II.7: Installation setup screen
Enter the passcode
Press the INSTALLATION SETUP soft key to access the form that
requires a passcode to be entered. The CANCEL and USE soft keys are
also available.
Enter the correct passcode (95148) and press the USE soft key or ENT
hard key. (Once you enter the passcode, it will not have to be entered
again until you cycle power.) This will open a form containing a list of
the INSTALLATION SETUP parameters and the following soft keys:
Function
Press to begin accessing the JOB SETUP
parameter.
Import or Export configuration file over the
serial port.
This will cancel all changes and exit from
INSTALLATION SETUP back to previous mode.
This will update with new settings and save any
changes to the configuration file before it exits.
This will open on-screen help.
116
Fig. II.6 POSITIP 880 screen after initial switch-on
Soft key
Fig. II.7 Installation setup screen
II Technical Information