HEIDENHAIN POSITIP 880 User Manual page 100

TOOL DESCRIPTION
If a tool presetter is used to measure the length of a
tool, enter the tool offset (25 mm) and press ENT.
Press USE soft key twice, then the USE NEW SETTINGS
soft key once.
The tool table may be protected to prevent changes from
being made to the tool information. Refer to II-2
Installation Setup.
Diameter axes
Select DIAMETER AXES to set the axis values to either diameter or
radius values depending on the requirements of the drawing. See Fig.
I.77.
Cursor to DIAMETER AXES and press ENT.
The cursor will be in the X axis field. (The field will default to
RADIUS). Depending on the parameter you need for that axis either
press the DIAMETER soft key or press ENT to leave as RADIUS and
advance to the next Z AXIS field.
Press USE, then USE NEW SETTINGS.
100
Fig. I.77 DIAMETER AXES form
I Operating Instructions