HEIDENHAIN POSITIP 880 User Manual page 44

Functions for drilling
Function
Press to go to previous hole.
Press to manually advance to the next hole.
Press to end drilling.
Example: Enter data and execute a circle pattern. See Fig. I.35 &
Fig. I.36.
Holes (no. of): 4
Coordinates of center: X = 50 mm / Y = 50 mm
Bolt circle radius: 20 mm
Start angle: Angle between X axis and first hole: 30°
Hole depth: Z = – 5 mm
1st step: Enter data
Operating mode: DISTANCE-TO-GO
Press FEATURES soft key.
Press CIRCLE PATTERN soft key.
Begin inputting data.
PATTERN TYPE
Enter the type of circle pattern (full).
Press ENT.
HOLES
Enter the number of holes (4).
Press ENT.
44
Soft key
Fig. I.35 CIRCLE PATTERN form
Fig. I.36 Circle pattern graphic
I Operating Instructions