HEIDENHAIN POSITIP 880 User Manual page 84

Tool table (Milling only)
The tool table will support up to 99 tools containing information on the
diameter, length and type. The length offset may be entered as a
known value or the POSITIP 880 may determine the offset
automatically. See Fig. I.61.
The following soft keys are available:
Function
Press to enter the tool offset length. Only
available in TOOL LENGTH field.
This will open the TOOL TYPES form for
selection. Only available in TYPE field.
This key will sort all entered tools by type (i.e.,
flat end mills with flat end mills, etc.).
This key will allow the operator to select
between tool axes (X,Y,Z).
84
Soft key
Fig. I.61 Tool table in milling
I Operating Instructions